Jesus Clips
 

Hi Guys,


I'm looking for all the best tips on installing the piston clips on RC engines.

My of the guys in my club call the 'Jesus' or 'Feckey' clips for obvious reasons.


Thanks in advance

Re: Jesus Clips
 

I need camera again. I do have very simple tool to install clips.
Never failed.
It is basecaly thin wall tubing OD 3.92 mm and ID 3.65 mm ( made out of steel). I am putting there clip without order ( under anydirection from the back of tubing) and then sticking this tubing to the wrist pin's hole on piston ( just couple of tens of mm) and them push out clip by rod diametrom 3.55 mm to the hole of piston.
Work great, never loose or bent any clips.