MT12 problems
can anybody give me a setup on the mt12?
|
Re: MT12 problems
Originally posted by rc-racer15 can anybody give me a setup on the mt12? HSN = 5 turns out, then start leaning 1/8th at a time if needed. LSN = 3 turns out, then lean or open as needed to get at least 30 seconds idle without engine clogin to the point of dying, it should hesitate a little after 30 seconds but not die. To do this, let engine idle then press full throtle for a second or two to clean it out, then check the 30 seconds idle. Mid Needle = flush with carb body with slot for screwdriver pointing the fuel inlet, then DON'T EVER TOUCH IT AGAIN. AFM |
What characteristics would an overly lean bottom end give? I'm having some setting issues and I could use some help. Thanks
|
Originally posted by gonzoY5 What characteristics would an overly lean bottom end give? I'm having some setting issues and I could use some help. Thanks Good Luck AFM http://www.teamtrinity.com/tech/nitrotune.asp http://www.teamtrinity.com/tips/nitro.asp |
All times are GMT -7. It is currently 07:31 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.