R/C Tech Forums - X12 Rody ...a basic question

R/C Tech Forums (https://www.rctech.net/forum/)

- Onroad Nitro Engine Zone (https://www.rctech.net/forum/onroad-nitro-engine-zone-71/)

- - X12 Rody ...a basic question (https://www.rctech.net/forum/onroad-nitro-engine-zone/40010-x12-rody-basic-question.html)

X12 Rody ...a basic question

Hi guys,

I installed a brand new X12 Rody and noticed than the Low-Speed Needle was set to 5 turns :eek:

I read on their web site that the low speed must be set initialy to 2 1/2 turn.

Some can clarify me on this. I am breaking-in the motor and want to make sure that I have the good low-needle setting.

By the way, what is your common after break-in setting with this motor?

Re: X12 Rody ...a basic question

Quote:

Originally posted by Frag
Hi guys,

I installed a brand new X12 Rody and noticed than the Low-Speed Needle was set to 5 turns :eek:

I read on their web site that the low speed must be set initialy to 2 1/2 turn.

Some can clarify me on this. I am breaking-in the motor and want to make sure that I have the good low-needle setting.

By the way, what is your common after break-in setting with this motor?

I'm not sure about how you count turns,... maybe,.. just maybe,... you count half-turns as 1 turn (5 turns by your way of counting is exactly 2 times the 2 1/2 turns recommended by RB)

maybe I'm wrong though,... but a carb won't be set that far off from the factory