R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Onroad Nitro Engine Zone (https://www.rctech.net/forum/onroad-nitro-engine-zone-71/)
-   -   Picco .28 carb (https://www.rctech.net/forum/onroad-nitro-engine-zone/324875-picco-28-carb.html)

latemodel13 09-04-2009 04:39 AM

Picco .28 carb
 
Is there another brand of carb that will fit the picco 28 that will be easier to adjust? I think the engine is good but the Picco carbs Suck. I am not new to nitro and have tried my best to tune this engine. Thanks

latemodel13 09-17-2009 10:03 AM

Carb
 
I figured it out. I had a sportwerks .26 that I took the carb off of. It was about .001 too big so I did a little sanding and it fit fine. I have to say not only was it easy to tune but this engine is so much faster it blows my mind.
I have ran alot of onroad and had some fast ones but they can't compare to this team turbo .28 picco with a carb that actually mixes the fuel right. I had tried 3 different picco carbs and none of them tuned right. I hope this helps anyone else that decides to try it.:nod:

danketchpel 01-14-2010 05:25 PM

I've been thinking to try a different carb in my Picco .28 Team Turbo also. I have 3 Piccos and I'm not so impressed with their carbs.

I have a RB S3 carb I and was going to see if it might fit. I also have a nice carb from a GRX.28 but the throat size is smaller than the Picco carb. I wish I could lay my hands on a O.S. carb sized properly.


All times are GMT -7. It is currently 05:58 PM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.