R/C Tech Forums - Tool for head clearance.

Page 2 of 2

Show 40 post(s) from this thread on one page

R/C Tech Forums (https://www.rctech.net/forum/)

- Onroad Nitro Engine Zone (https://www.rctech.net/forum/onroad-nitro-engine-zone-71/)

- - Tool for head clearance. (https://www.rctech.net/forum/onroad-nitro-engine-zone/234240-tool-head-clearance.html)

lil-bump

08-20-2008 06:52 PM

Quote:

Originally Posted by wingracer (Post 4758055)

Well, for flat top pistons just but the tool in the head with the head off and push it down on a flat surface. Then zero it and put it on the motor. Off course, by the time you did all that the solder trick would have given you the answer.

Ditto

fly_wheel

08-21-2008 05:04 AM

thanks roelof...

dj apolaro

08-21-2008 05:45 AM

Thanks guys for your help. I am good now. I am just using the same old solder method.

DJ

wingracer

08-21-2008 05:50 AM

Quote:

Originally Posted by dj apolaro (Post 4760175)

Thanks guys for your help. I am good now. I am just using the same old solder method.

DJ

As crude as it may seem it really is the best way.

All times are GMT -7. It is currently 09:52 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page