R/C Tech Forums - O rings on needles

R/C Tech Forums (https://www.rctech.net/forum/)

- Onroad Nitro Engine Zone (https://www.rctech.net/forum/onroad-nitro-engine-zone-71/)

- - O rings on needles (https://www.rctech.net/forum/onroad-nitro-engine-zone/217305-o-rings-needles.html)

keavze

04-15-2008 06:24 PM

O rings on needles

hi,
just wana check are there any ways to replace the O rings on the LSN n HSN needles without tearing/fraying of the O rings?

i've just replaced mine and it's TIGHT. after i fully closed it and backed out to the desired settings, the O rings deformed and frayed... :(

any suggestions? :sweat:

kcrunchone

04-15-2008 07:26 PM

Lubrication is my method. Ky-effect LOL...

keavze

04-16-2008 05:08 AM

Quote:

Originally Posted by kcrunchone (Post 4358997)

Lubrication is my method. Ky-effect LOL...

ya, tried that (not KY though... :lol:) but still same... :cry:

jameslow

04-16-2008 05:38 AM

Maybe u can check the internal surface of the needle screws holes! Check if there is scratches that casue tearing to the o ring!:sweat:

All times are GMT -7. It is currently 09:55 PM.