R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Onroad Nitro Engine Zone (https://www.rctech.net/forum/onroad-nitro-engine-zone-71/)
-   -   Kyosho GXR-15 Motor Thread (https://www.rctech.net/forum/onroad-nitro-engine-zone/114022-kyosho-gxr-15-motor-thread.html)

KYOSHORACER 05-15-2006 04:16 AM

Kyosho GXR-15 Motor Thread
 
Anyone else run this Pull Start motor???

Whats some tips and tricks that people are doing to them.

What temp plugs etc?

What mods?

Etc Etc Etc!!!

Nightkestrel 05-19-2006 06:04 PM

I run this motor.
Haven't really done anything to it yet, as my kit is relatively new.
Do you remember the stock settings for the high and low end needle?
My friend helped me tune the engine after break-in and we forgot the settings.

Currently having a bit of problems after putting my car away for 10 days (yes, afterrun was added)
Engine is NOT revving most of the time.
Just get a deep exhaust note, and the car runs at a super slow "break-in" speed :weird:

MCRUZ 05-23-2006 12:33 AM


Originally Posted by KYOSHORACER
Anyone else run this Pull Start motor???

Whats some tips and tricks that people are doing to them.

What temp plugs etc?

What mods?

Etc Etc Etc!!!

temp should be around 250 or so but just look on how much smoke is blowing and try to read the plug. the best advice I can give you is to use gasket sealant everywhere you can like the carb etc...


All times are GMT -7. It is currently 04:57 AM.

Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.