Have you ever tried boiling a cylinder to test pinch?
I figured if I boiled my cylinders I might be able to simulate a 200 deg head temp, or
at least expand the cylinder enough to allow the piston to move further up the cylinder. But it didn't. How hot do you preheat a cylinder during break-in, or before a race? I noticed my cylinder cooled down really fast, how long will a cylinder stay warm after the heater has been removed? thanks Bill M. |
Be aware that normally inside the cilinder it is much hotter causing some extra expansion, also the piston has a highe temp.
Pre-heaten is done with hair dryers, paining removal heatguns, or special RC heater products like competition heat, sure start etc. |
All times are GMT -7. It is currently 03:50 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.