Need help please
Hi everyone I recently bought a cen mg10 Mt3, I had it out today but after starting her up and accelerating she kept cutting out after a burst of acceleration. I could smell a smell of melted plastic after trying a few times. I'm a noob to RC cars so if anyone knows what's wrong or could be wrong or has any information at all that would help me it would be really appreciated thank you.
|
melted the fuel tank and air is getting in?
|
Originally Posted by 1TUFSPARTAN
(Post 11292786)
melted the fuel tank and air is getting in?
|
Just a thought...try to mess with your needles a little. Maybe your just too rich/lean?
|
read the tuning bible at the top of the nitro engine thread
|
When it's in idle it's accelerating a bit is this normal ? Could I hav the remote set up wrong ?
Thanks ncdirtracer. |
Accelerating for a short burst, then cutting out when you apply full throttle is a lean bog.....the engine isn't getting enough fuel to feed it properly at full throttle. Richen your high speed needle a quarter of a turn. If it still does it, richen it another quarter turn.
Once it's very rich, and blubbery at full throttle, start leaning it out 1 hour at a time until the performance is good, but it's not lean bogging. That "smell of melted plastic" was your engine getting extremely hot from running too lean.....good way to destroy it in a hurry..... |
Originally Posted by Gazbhoy
(Post 11292768)
Hi everyone I recently bought a cen mg10 Mt3, I had it out today but after starting her up and accelerating she kept cutting out after a burst of acceleration. I could smell a smell of melted plastic after trying a few times. I'm a noob to RC cars so if anyone knows what's wrong or could be wrong or has any information at all that would help me it would be really appreciated thank you.
|
All times are GMT -7. It is currently 07:45 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.