Nitro Stalls at Acceleration
 

Hello,

I have a Taymia TNX 52R, the car has been shelved for a few years. My problem is that during acceleration it stalls. Any help would be greatly received.

Thanks in advanced

DARN BRO, there could be alot of reasons y it will not run
old gaskets in carb
ur carb tune
air leaks
old fuel
old fuel line
tired motor
need a new glow plug????
front bearing need replaced
these r just my ideas of the top of my head??? but good luck man. maybe it is something easy i didnt think of.

Thanks, I can rule out old fuel, the engine has only been run 10 times max.

then it's probably too lean or has some junk in the fuel tubing/ carb

Check the glow plug and use new fuel, or make sure glow plug is fully charged and fairly new. If there's a lot of smoke on takeoff and slow acceleration it's likely too rich.

If everything else is ok, eg plug, fuel, lines, etc then I would richen your bottom end.

Thanks for the replies!
I'm thinking there's stuff in the carburetor. Is it possible to have stuff in the Combustion Chamber (under the glow plug)? Any other solutions are very welcome.

it could be gummed up inside take back plate off and look at rear bearing to see if any rust.i had a boat motor that did same on take off it was bearings