Newb engine bearing help?
#1
Newb engine bearing help?
Hi I am rebuilding my first nitro motor. It a VX .18 and the front and rear bearings are shielded 10x19x5mm. The direct replacement bearings are only available from overseas and cost more than the motor is worth.
Question is, will any shielded radial bearing work or is there a specific rating or type for nitro motors?
I just bought 2 6800ZZ from rc bearings.com, will those work?
Thanks
Question is, will any shielded radial bearing work or is there a specific rating or type for nitro motors?
I just bought 2 6800ZZ from rc bearings.com, will those work?
Thanks
Last edited by Hudsonaj36; 12-01-2011 at 01:57 PM.
#3
Yeah it's just a cheapo motor.
I always thought the front bearing would be sealed to avoid air leaks but this appears to be shielded as I can see some daylight through it. Is it common for low end motors to have shielded instead of sealed bearings?
I always thought the front bearing would be sealed to avoid air leaks but this appears to be shielded as I can see some daylight through it. Is it common for low end motors to have shielded instead of sealed bearings?
#4
Wow thats asking for problems
#6
Cool, unless anyone thinks of a reason not to I am going to put a sealed bearing up front.
Thanks for your help
Thanks for your help
#7