235mm Class

You're on Page 10 of 10
Go to
  • Quote: Hello,

    anyone of you guys has the clutch for 835 or impact for sale?
    It will work with other Serpent clutches (if that helps); http://www.serpent.com/product/909510
  • Quote: The engine mounting holes on the impact are further apart compared to the Impulse, you can tell by looking at the small block engine mounts for impact (808381) on their site. From what i have read this is the only option for mounting a small block on the Impact M2. My question was if i want to run a .21 big block, could i use mounts from the 950 chassis? I know the mounts will need to be taller than the stock .15 big block mounts.
    Correct on the Impulse, Mount just bolt on. Impact & Vector Has eccentric mounting on the chassis. Lookin' on both chassis( which I have in frt of me) Vector mounts can be interchangeable to mount .21 engine. Bolt pattern to chassis are the same. Cant remember if 950 will fit.
  • Does anyone know the part number to the bushings that go to the rear body mount Serpent Impact m2?
  • Quote: Does anyone know the part number to the bushings that go to the rear body mount Serpent Impact m2?
    #808136 If you cant read the number

    235mm Class-impact-m2-rear-body-mount-001.jpg  

  • Thanks! I found them at ashfordhobby.com, i'm so excited to get my vintage impact m2 going again!
  • Quote: Thanks! I found them at ashfordhobby.com, i'm so excited to get my vintage impact m2 going again!
    I've been dealing with Robert at Ashfordhobbies since 1992. He has a good inventory of must parts. The Vector, Impact & Impulse were purchase though him when he was in Connecticut. Have history wit Asford Hobbies.

Similar Threads