Mugen MTX-3

You're on Page 186 of 1150
Go to
  • Quote:
    Originally posted by Nytrochaos
    I buy from speedtech, and they are ascheapas anybody

    Look at my question a couple .....
    ...by the way, you wont go wrong with this car
    thnx Nytrochaos.. woo hoo I already ordered the one without the engine. They said they are going to ship it monday so i'll probably have it by the end of the week. Just in time to build it on weekends. I just can't wait. thnx guys <---- tears of joy
  • Hi Guys,

    Thanks for the advice.

    I do have the alloy mid bearing block I'll check to see if the belt is rubbing.


    All the best
  • Re: Re: Re: Front belt wear
    Quote:
    Originally posted by Cartman
    do you have and alloy mid block? i do and my belt was rubbing on there! had to get my dremal out!
    Nope, using the plastic ones, but needed to slightly dremel them. As for the front belt tension I'll adjust using small washers on the front screws of the mid block. Isn't a true tensioner but permits to do small adjustments.


  • Kawahara 4mm chassis for MTX3.
  • That chassis is sweet.
  • Quote:
    Originally posted by Manticore
    Kawahara 4mm chassis for MTX3.
    Got another chassis?


  • NEGGATIVE REAR DIFF FOR MTX3 IS OUT FROM KAWAHARA-$95
  • Where can you get all this great kawahara stuff?
  • what are the sizes of hex (or metric) drivers that ur going to use when building the kit (w/o engine). Does the kit come with them already or they are junk just like the ones on NTC3 kit? many many thnx.
  • Quote:
    Originally posted by penggoy
    what are the sizes of hex (or metric) drivers that ur going to use when building the kit (w/o engine). Does the kit come with them already or they are junk just like the ones on NTC3 kit? many many thnx.
    2mm
  • Quote:
    Originally posted by Corse-R
    Got another chassis?
    no, mugen one is better.
  • is the mugen chassis really better? that kawahara one looks pretty intense
  • anybody knows a website of where I can purchase a rx pack made from mugen ?
  • www.speedtechrc.com
  • just finished broken in my Rody Tuned 5 port, i took a spin of the 3...oh man.. this car is sweet it has plenty of steering and the turning is accurate, the car never fishtail when power hard out of turns...all i can say - no regret!!!
    i ran too low that the rear Mugen 4mm chassis bottom out and got scratched....oh my new chassis...

Similar Threads