99LikesSerpent Cobra GT
10-17-2013, 03:51 PM
#811
10-23-2013, 04:13 PM
#812
Tech Rookie
Good evening gentlemen.
I am having issues with my rear axle pin lining up in the axle? I did one side no prob slipped right in. HOWEVER. This one is giving me a really hard time... I do not know what to do..
This is really maddening. Any advice?
I am having issues with my rear axle pin lining up in the axle? I did one side no prob slipped right in. HOWEVER. This one is giving me a really hard time... I do not know what to do..
This is really maddening. Any advice?
10-24-2013, 10:51 AM
#814
Tech Rookie
I will take a picture tonight. Thanks
10-25-2013, 03:17 AM
#815
Tech Initiate
EVO13 how do you find the murnan virtus?
11-02-2013, 08:41 PM
#818
The car looked dangerous! Not to mention I geared it up beforehand.
11-03-2013, 08:55 AM
#820
What would the low role center rear bracket do for performance?
11-04-2013, 07:07 AM
#821
Are these the upgraded brakes for this kit or are these for the buggy/truggy???
http://www.igthobbies.com/SERPENT-SE...O-_p_3022.html
http://www.igthobbies.com/SERPENT-SE...O-_p_3022.html
11-04-2013, 07:50 AM
#822
Hey Brett what's up! If I'm not mistaken, if you lower your rear roll center it will increase the distance between roll center and center of gravity and the car will roll more in the corners. I think the effect of that is to utilize more of the available traction/grip for a given surface. It should help go harder on throttle without having the rear wash out of the corners but the downside of that could be less corner speed. I think that it is then possible to compensate with a harder shock setup.
Last edited by Joe Kimble; 11-04-2013 at 11:01 AM.
11-04-2013, 07:57 AM
#823
Are these the upgraded brakes for this kit or are these for the buggy/truggy???
http://www.igthobbies.com/SERPENT-SE...O-_p_3022.html
http://www.igthobbies.com/SERPENT-SE...O-_p_3022.html
11-04-2013, 09:29 AM
#824
