NTC3 nitro throttle return spring ideas for slide carb motors?
Can anyone help me with any ideas on setups for a throttle return spring? I have a couple ideas but want to see what you folks out there have it set up. Thanks.
|
When I was running a NTC3, I used a rubber band from the needle valve assy. around the pivot ball on the other side.
|
I did what Red said except instead of a rubber band, I just cut the top off a small balloon and stretched it to fit. Works great on all the Itilian and Japanese engines.
|
Thanks folks. I'll give both ideas a try.
|
balloon
Originally posted by calstarjig90j Thanks folks. I'll give both ideas a try. can use it to WATERPROOF my RX also!!!! last night i tried to use spring... my RTR servo cant OPEN the carb slide 100%... the spring is too hard for the servo.... shucks! :tire: mop:tire: |
rubberband works the best
|
All times are GMT -7. It is currently 12:55 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.