kyosho protein alpha gp (Rebuild) (Take 2)
5 Attachment(s)
Hi
I got this car in kit for when i was 13 & started to build it 2 years later. I managed to get the car running after building it & realising the cylinder sleve/liner wasnnt in correct (ready to run engine too ) after turning that 90 degrees & getting it fired up everything was hunkey dorey BUT... after using it about 3 runs i tryed to set off & the engine would rev slightly even when flat out but the car woudnt/coudnt move. I adjusted the brakes & rebuilt the cluch thinking that the brake or cluch was sticking & it was fine after that for another 4 runs. At about its 7th run it seemed to have the sticking problem a couple of times. on its 8th run it woudnt start & loads of fuel came out of the exhaust & other unusual places & their seemed to be hardley any compression when pulling the starting cord (GX-12 engine). I have finnaly got it back out & come to the conclusion that the sleve/liner or piston is damaged. Im thinking of getting a GX-15 engine for my car but i want more power then i found a GXR-15 but i cant seem to find one with a cluch allready attached & i dont know if it will fit. Anybody know the diference between the Kyosho GX-12, GX-15 & GXR-15? what i have done: I have stripped most of the chassis down (AGAIN) Full set of Oil shocks (cant remember what make) New radio gear What im going to try & do: Get much more powerful servos Failsafe (my last one was dodgy) Kyosh GX-15/GXR-15 engine Alloy wheels so i dont demolish them lik emy crappy plastic ones that came with the kit Begginers luck MY ASS never came to me & this was a begginers kit (Advice & Ideas are welcome) |
All times are GMT -7. It is currently 03:23 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.