gotmotor

The 8th scale track up yet Billy so we can come up?

YLLIB

iTrader: (1)

Yes, race this Sunday......

gotmotor

Going to try this out maybe this wknd I'll let you guys know how it holds up.
CSO if your looking at this why dont you make something like this for the five

gotmotor

This was made by MSO...#ike WHOOOOOOOOO

CanyonCarverR1

iTrader: (13)

You running the "B" upper arm plate?

CFowler

iTrader: (1)

Ahh, you and I were thinking along the same lines, But with this I used all Mugen parts

Go over to Mugen Training Camp for a complete parts list

Chris

gotmotor

Oh but grasshopper U looking at wong ting it's the aluminum part is why I post
pic not the spacer I feel that the plactic piece cant take the impact of my driving

nitrodude

iTrader: (8)

How big is that turnbuckle? 3mm or 4mm?

I where that orange spacer came from

wingracer

iTrader: (24)

And you are looking at the wrong thing too

That plastic part may be Mugen but it's not the stock part.

CFowler

iTrader: (1)

It doesn't break, it pops off ... it becomes the weak link without destroying anything else. But you have to tag something hard.

In my case hard enough to break the shock shaft and crack the lower A arm, drove it back to the pits.

It is an improvement to the original part that would snap off rather easily, and you probably have all of this stuff in your pit box. Mugen Drew switched his car over sitting next to me at Homestead, told me he sent photos to Mr. Sonata in Japan

Mr. Sonata thought it was well done.

gotmotor

The turnbuckle was milled to the stock part and you know where the orange
spacer came from

I know its not Mugen but I wish they'd make like this or CSO......HELLO!!!!!
Make this also its part of the car too

gotmotor

Went to MTC....not bad not bad Ill try that also gota keep it real in the
MTC

Team Kamikaze

iTrader: (3)

I got plenty of those turnbuckles in stock

gotmotor

Your funny

ralphierace13

iTrader: (5)

i dont know bout u guys but i never had the plastic ball end pop off every time i had a problem it was the turnbuckle snaped like a tootpick so i dont think this would solve the issue unless u put a 4mm turnbuckle to make it stronger. i think mugen should just make an alum piece that sits on top were the ball end is now that screws into the a,b,c plate that looks like the bottom of the knuckle and has the hole to put a pivit ball throu like the bottom and just make a new upper arm so u can screw the pivit ball right in problem sloved,