Serpent 733 1/10 200mm touring
#3421
does anyone have any other ways of charging the IP 1450 life battery while its still in the car. i have figured out how i can wire it but i cant find a way in which i can charge it. i would have to take the top deck off the car every time if i wanted to charge it.
#3422
i use the ip battery i and i do pass the power cable to the back of
the tank and do the connection with the receiver power cable on the
top of the receiver box. i do not use a switch. This way its easy to charge it
without removing a thing.
However the balancer cable is too small to reach the top of the receiver box or
somewhere you can connect it with the balancer adapter.
I do not balance the battery on every charge, only on races and this can be
done by removing the tank (which is pretty easy). If you want to balance it on
every charging (which i personally find unessecary) you must provide a longer balancer cable.
if using a switch just put the power cable to the antenna hole of the receiver box and do
the connection inside.
the tank and do the connection with the receiver power cable on the
top of the receiver box. i do not use a switch. This way its easy to charge it
without removing a thing.
However the balancer cable is too small to reach the top of the receiver box or
somewhere you can connect it with the balancer adapter.
I do not balance the battery on every charge, only on races and this can be
done by removing the tank (which is pretty easy). If you want to balance it on
every charging (which i personally find unessecary) you must provide a longer balancer cable.
if using a switch just put the power cable to the antenna hole of the receiver box and do
the connection inside.
Last edited by gfilos; 02-26-2011 at 11:23 PM.
#3423
thx gfilos i have it sorted now
#3425
Hi all
Could anybody tell me what number servo horn to use for sanwa servos on the 733.
Cant find it in the manual
Many thanks
Could anybody tell me what number servo horn to use for sanwa servos on the 733.
Cant find it in the manual
Many thanks
#3426
#3427
Thank you julius
#3428
I just picked up a 733 today and i am currently running a sirio engine. Is the optional motor mount required to run these engines??
#3430
pooop... so no fit?? lol I was even thinking about it seeing as I ran the same engine in my 720
#3433
Hi guys,
just started building the 733 evo and can't find the part no 804228 in the kit.Does anybody know if it comes in the kit or is an optional and where can I get it?
just started building the 733 evo and can't find the part no 804228 in the kit.Does anybody know if it comes in the kit or is an optional and where can I get it?
#3434
I asked the same question. It seems they are not released yet. I machined them myself.
#3435
Thanks for info,it's a real shame as it means that the car is incomplete for setting up changes