Ultraspeed84

iTrader: (45)

http://www.amainhobbies.com/product_...-Balancer-Plug

will this battery fit my 733 thanks

Pattojnr

iTrader: (19)

http://cgi.ebay.com.au/Intellect-Li-...item3caa00cff6
this is the one i use. i see the dimensions are slightly smaller than the one you listed.

Team-RTR

i also use the one patto jnr listed, it fits nice and snugly in the car plus you dont need to run a regulator, any bigger then the intillect li-fe pack and you run the rusk of the receiver pack rubbing on the side belt.

Ultraspeed84

iTrader: (45)

thanks guys i just bought that one u posted up... i think it will work fine...

Ultraspeed84

iTrader: (45)

what body will be the most stable on this car?

ProE

Will the 720 steel pinions work with the 733 spur gears?

Azizi

iTrader: (6)

u can try Mazda 6 or Dodge Stratus.

J-MAN

iTrader: (1)

Just finished building a 733 for a freind of mine, and i can say it was the easiest build of a 1/10th scale ive ever done! everything went together smooth, no bidding in the arms, and the drive train was free from the get go! This car is so easy to work on its a very well designed car! I look forward to getting one soon! I run the 966 but i think i need a 733!

Team-RTR

what grease are you guys running on your 2 speed oneways? read a few pages back serpent oneway lube is no good for the new style bearings, is this actually the case?

Pattojnr

iTrader: (19)

i have used ball diff grease on initial use.
then just a little every once and a while. Tamiya ceramic grease i used.

Serpent-Dan

iTrader: (18)

Xceed A5 and Blitz 2.3

NiTrO BoOsTeR

iTrader: (7)

hey guys im building my 733 and im up to setting the clutch. i cant get the .7mm gap, im running a Novarossi 3SCT tuned engine and it almost like the bolt that holds the thrust bearing holder inplace isnt long enough to bottom out in the crankshaft. im using the flywheel cone that came with the engine, could i take a little bit off the cone, would this help or am i doing something wrong.

Thanks guys

dj apolaro

You can do that or try another cone. Make sure there is no spacer behind the cone also. It is not needed.

DJ Apolaro

NiTrO BoOsTeR

iTrader: (7)

thanks for that

Mitchell

ProE

Anyone?