ozziii

Does it mount in the same place as the plastic one or is it longer, similar to the Black Edition chassis brace. I think they need to be longer & mount on the chassis up beside the engine mount somewhere to reduce the chassis flex, like the B.E.

UrabusDenis

On the same place as the plastic one, just with two screws on the chassis

ozziii

I think the short brace is the problem, not sure if 2 screws will make much of a difference, will be interesting to see how it works for you though.

On another subject, does anyone know where I can find the pics & info showing where to grind the front arms for more droop, just want to check & make sure I'm getting it done properly.

UrabusDenis

Here it is

THE WE LV Setup Guide ? JQRacing

Banshee8530

iTrader: (1)

I just upgraded my W.E. with LV parts and used the LV kit setup. My rear outer camber link ends rub the inside of the wheels pretty good. Anyone else experience this?

speedy2

iTrader: (1)

did you use all the LV parts ? rear uprights, rear toe/squat plates and tower

UrabusDenis

Weird, people have experienced this with the Black Edition geometry and new Schumacher astro tires, but not before. As asked, did you use the whole LV rear? It's all combined

Banshee8530

iTrader: (1)

Yes, R-F and R-R hinge pin blocks (both orange), LV rear tower, and LV Hubs right and left. Did I miss something? I have the camber links mounted in the top middle hole on the hubs. Wheels are old Avid with AKA enduros mounted.

ttr_racer

iTrader: (49)

Yes, I too had that problem. I was using Jconcepts wheels and they rubbed a flat spot on the upper link from rubbing the wheel

Banshee8530

iTrader: (1)

I just installed a set of pre-mounted AKA tires and wheels. They rub, too, but much less than the old set I had on there.

I think the age of the wheels/tires combined with my local climate might have something to do with it (low humidity and high-ish elevation). A little shrinkage of the rubber and plastic can be expected over time.

Kyosho Kid

iTrader: (12)

Did you install the end links upside down?

Banshee8530

iTrader: (1)

Nope. It's just the large OD around the ball socket that hits. I'll likely be dropping the link to the lower holes for low traction anyway, so no big deal.

Mikeymike954

So I have a WE converted electric with factory e conversion from JQ. Ive been searching and searching on here for what type of bodies fit car. I know bittyforce has one, but any other ones? Thanks in advance

Kyosho Kid

iTrader: (12)

Mp9 mbx7r xb8

Mikeymike954

Thanks bud, appreciate it. Do I get the nitro version of the bodies or electric?