Serpent 811 Cobra Buggy
#7051
#7052
Haha My friends did the same thing
#7053
#7054
Tech Initiate
trust me on this sean, they will rue the day they laughed i had the exact same thing when i bought my cobra, and seeing as i run in the uk and i have only ever seen one other over here being used they all thought i was mad.
But now they are laughing on the other side of their faces especially as i made the champion of champions and now rank 5th on the over 40's national level over here. every single one of them has commented on how dialled the buggy is. And one of my strongest mickey takers has tried three different cars too try and keep up and still cant, one agama one jq and a losi later.
But now they are laughing on the other side of their faces especially as i made the champion of champions and now rank 5th on the over 40's national level over here. every single one of them has commented on how dialled the buggy is. And one of my strongest mickey takers has tried three different cars too try and keep up and still cant, one agama one jq and a losi later.
#7055
Well so far so good, all the diffs are built and the center one is mounted to the chassis. I'm talking pictures after each step of the build so people that don't own one can see the processes. The plastic on this car is very tough and tolerances are tight, which I like. So far I'm a happier camper
#7057
That was my main issue. I just didn't know how long the Robo/Hudy/etc were. The stocker is a little longer then the generic aluminum arms, so I went with a really long one.
#7058
Tech Regular
iTrader: (1)
Is anyone running this Team Orion 1900 mah battery?
http://www.redrc.net/2010/01/team-or...0-xl-rx-packs/
Will it fit the v2 tray?
Thanks
http://www.redrc.net/2010/01/team-or...0-xl-rx-packs/
Will it fit the v2 tray?
Thanks
#7059
The 1900 hump pack fits nicely!
#7060
#7061
Anyone have a link to the Robitronic servo arm that fits for brakes on the new tray? I see a bunch, not sure which one it is.
#7062
Tech Master
iTrader: (47)
It works really great. Just installed it. Drill a 13/64 hole through the top hole.
It fits the swivle great.
http://www.amainhobbies.com/product_...-Red-24T-Hitec
RBOR17002 Robitronic Machined Aluminum Single Sided Servo
It fits the swivle great.
http://www.amainhobbies.com/product_...-Red-24T-Hitec
RBOR17002 Robitronic Machined Aluminum Single Sided Servo
#7063
I think Hangar 9 makes one also. I don't know the part number either. Lol
#7064
#7065