Proper Gear mesh
#1
Proper Gear mesh
I have a RC8T and will be installing the engine. How do you guys set this up to get the right gear mesh.?
Thanks
bguad
Thanks
bguad
#2
Tech Addict
It is a matter of feeling, I believe.
But some people use a piece of paper between the spur and the clutchbell. Then they push the motor & clutch-bell as far in as they can, and then remove the paper. But I haven't used these, so I don't know if it works.
But some people use a piece of paper between the spur and the clutchbell. Then they push the motor & clutch-bell as far in as they can, and then remove the paper. But I haven't used these, so I don't know if it works.
#4
Tech Master
iTrader: (32)
clutch bell, should only rock back and forward(approx 1-2mm), but keep in mind, that once you tighten up the screws, it may decrease the movement
between the gears, if it tightens, just loosen screws slightly and move mota a fraction, then re-tighten, if ur gear mesh is too tight, you will hear it when ya move truggy back & forward, also dont forget to use loctite on screws under chassis(bottom) And if you have to remove ur mota in future, take out the screws that hold mota to engine mount..hope this helps ya..good luck..