OFNA Hyper 7 buggy .21 3 port engine needle settings
could someone tell me what are the needle settings for the .21 3 port Hyper engine that comes in the Hyper 7 RTR buggy?
Thanks Dylan |
for break in?
|
yes. we used the settings that were in the break in manual and they didnt work at all. it would only start a couple times and when it did it was wayy to lean. the tempurature was in the low 70's during the beginning of break in
|
Originally Posted by Quad Racer 34
(Post 6023454)
yes. we used the settings that were in the break in manual and they didnt work at all. it would only start a couple times and when it did it was wayy to lean. the tempurature was in the low 70's during the beginning of break in
|
i used the manual break in settings and it went good
|
yea they were too lean. we richened them up a bit and finally got it running.
|
All times are GMT -7. It is currently 04:26 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.