R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Nitro Off-Road (https://www.rctech.net/forum/nitro-off-road-130/)
-   -   NEED HELP MBX5r (https://www.rctech.net/forum/nitro-off-road/292458-need-help-mbx5r.html)

slipknotanfitch 04-24-2009 11:17 PM
NEED HELP MBX5r
 
Ok so i got this MBX5r from a friend becuase he wasnt using it and i wanna put an axial .28 PS on it that i have laying around BUT the motor mounts put the clutchbell up to far and I cant move it back. Any ideas??? after market motor mount, anything. Ya and an ofna mount DEFF wont work too wide tried pulling one off an old hyper that I have

slipknotanfitch 04-25-2009 09:13 AM
Cmon i need help guys:cry:

GREGORY! 04-25-2009 09:31 AM
Originally Posted by slipknotanfitch (Post 5730570)
Cmon i need help guys:cry:

buy the 2 piece engine mount,it's cheap.then you will can put a pullstart motor.

o.s. power 04-25-2009 07:15 PM
Originally Posted by slipknotanfitch (Post 5729677)
Ok so i got this MBX5r from a friend becuase he wasnt using it and i wanna put an axial .28 PS on it that i have laying around BUT the motor mounts put the clutchbell up to far and I cant move it back. Any ideas??? after market motor mount, anything. Ya and an ofna mount DEFF wont work too wide tried pulling one off an old hyper that I have
the 5R was not meant to have a pullstart motor installed. you would need to install a larger flywheel as you would have to find motor mounts taller than the stock ones to clear the pull start. a 2 piece i doubt would give you the needed clearance.

mamba4life 04-25-2009 08:32 PM
a .28 wow dude i freaked out when i started winning more and doing better when i went down to a .21!:nod::nod::nod:


All times are GMT -7. It is currently 06:09 AM.

Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.