os speed question
finished xray xb8ec yesterday and was working on the tune for it and man is it complicated but this speed motor is "holy *censored* fast"..
if anyone knows factory or good screw settings for os speed magnesium head motor let me know also not sure bout this spektrum radio(DX3.0) deal as it seemed to start glitching a little towards the end of my night. not sure what it is but im running a lipo regulated |
I think it's kind of hard for someone to give you their needle settings and have them work for you, cause carb settings vary depending on many variables, so what works for someone doesn't mean it's going to work for you, so I would be very cautious with that, just make sure you have plenty of smoke, lots of power and it's not overheating and you should be fine.
As far as your system glitching it could be anything, you will have to eliminate possible causes (dead batterys, bad switch... and the list goes on and on) and trust me, this can be a pain in the neck!!!!:nod: |
ya i know im just curious as factory settings mainly to see how far i am. it seems this motor has to be tuned really lean to not load up and die out.
for the spektrum system ya im not sure i didnt check temp on regulator as i ran out of day light but it seemed some times my throttle servo glitched and like wen i let off the throttle it delayed |
All times are GMT -7. It is currently 08:51 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.