os .21 RG backplate option?
#1
os .21 RG backplate option?
i have an old but new in box os .21 RG sport buggy engine, i would like to fit it in my buggy but the backplate is too big, also i would like to change it for a rotostart backplate (now it's pullstart) and i was wondering if this backplate would fit http://store.outacontrolhobbies.com/xtm24ba.html
#6
i think this will works, any idea
this shaft http://www3.towerhobbies.com/cgi-bin...?&I=LXPUF8&P=M
since mine is 8mm and will use the VG (6mm) and also use the VG backplate http://www3.towerhobbies.com/cgi-bin...?&I=LXPUF7&P=7
this shaft http://www3.towerhobbies.com/cgi-bin...?&I=LXPUF8&P=M
since mine is 8mm and will use the VG (6mm) and also use the VG backplate http://www3.towerhobbies.com/cgi-bin...?&I=LXPUF7&P=7
#8
because the backplate is just too big and i have 2 other problems, i can't fit the exhaust coupler at the back to install my manifold since on this engine you have to buy the OS manifold... and the coupler run against the backplate, maybe i can dremel it a bit... and also because the backplate also rub against the chassis since the engine mount are not tall enough, this backplate is really big...