werks .21 7port pro ???
just had a couple of questions about the werks .21 7port engine
1:what are factory setting for the carb neeedles 2:what plug works best (heat and brand) 3:head shims 4:pipe 5:recommended temp and any other helpful hints so i can get my engine running better...flame outs and mega torque are hindering my performance..just want a smooth running engine and it is very erratic |
I will have to bite my tounge on this one.
|
I have the B3 and i found it ran the best with a werks pipe, go figure. I run a medium plug with 30% nitro. Your motor come from the factory already shimmed for 30%, so if that is what you are running then your fine. I ha problems with it stallng all the time when I was getting temps in the 220-230 rang, now the temps are up to 260-270, but it never stalls. These werks motors MUST be warmed up before you do any tuning or racing.
|
http://www.rctech.net/forum/showthread.php?t=205086
Try this,it should help or serch werks .21 b3 pro they have a lot of info on the 7pro there. :spidey: |
i forgot to mention that the flame out problem is only when i come to an idle and it seems to load up.. and then flame out...
|
All times are GMT -7. It is currently 08:17 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.