tunning vspec
ok guys i have a vspec and running it with the jp3 pipe im temping around 210ish but it doesent realy rev very well at the top.i noticed the idle gap was to wide o i have set it to .5mm per the manual i need to run it again but any help or hints greatly recieved as i like this motor
cheers in advance |
If it seems like it's not clearing out at full throttle, lean out the high speed needle... just make sure you can still see smoke...
|
Spud, start here:
2 1/4 out from closed on top 3/4 in from flush on bottom mid needle flush with carb body Then lean the top till it is good, then bottom at idle once its up to temp, lastly set the idle gap if its too high or low. |
cheers guys will try that tomorrow
|
All times are GMT -7. It is currently 02:40 AM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.