Water Proof
yes i know this is probably a repeat BUT i used the search forum thing and could not find anything.
how do you water proof the electronics? |
in the october 2007 issue of rc car magazine they have a article all about preping your car for wet weather, I will list everything they cover. Also just to make sure you know, even with all this preperation if a drop of water somehow gets to the wrong spot that electronic can get ruined these are just steps to prevent it as much as possible. this is also for performance but for wet weather racing you want more than just electronic protection, you want to keep your whole car protected
Balloon your reciever Put silicone around where your wires exit the servo, and thick grease on the base of the output gear on the servo Duct tape on the suspension arms, put some on the bottom and a sheild in the front to keep mud from building up on the arms Wheel scrapers Lube your bearings before and after piece of lexan in front of your air filter to keep the water out of it So basicialy ballon your reciever, put something like shoe goo around where the wires come out of the reciever and thick grease around the base of the output shaft on the servo |
All times are GMT -7. It is currently 07:31 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.