Team Associated 1/8 scale Truggy Info and Tips
12-04-2009, 09:42 AM
#902
were do you guys musure for ride hight front and back. do you go to the flat spot or the tip of the kick up part by the bumper?
12-06-2009, 05:48 AM
#904
I have maybe 10 runs (if that much)on my RC8T FT and I noticed the rear, front arm holes hallowed out in an oval and rear holes of the rear arm still circular. I replaced the rear arms and if it happens to my RC8B and again to my RC8T looks like I may sell them.
Waste of money if I would have to replace the arms after every 10 runs or less.
Waste of money if I would have to replace the arms after every 10 runs or less.
12-08-2009, 07:52 AM
#908
The oil is comming out from the top or the bottom seals? If it is comming from the top its either the top is not screwed completly or the bladder is damaged or not seated correctly. If its comming from the bottom then rebuilt your shocks with new seals but like the guys said earlier take a close look at the shaft for bending or scratches. If it has either then replace the shaft.
12-08-2009, 08:44 AM
#910
If the tune is good then all that's left is the tank and fuel line. I would start by replacing the fuel line it's cheap and then if it still does it change the tank. I have had new tanks have problems from the start. There's nothing else that can cause flame out issues.
12-08-2009, 02:49 PM
#913
are you running your tank almost dry when you pit? and how full do you fill it? i have had this issue befor cuz i was running it almost dry and my pitguy would over flow the tank when fueling so when the lid slapped down it would push exrta fuel threw it causing it to stall.
12-09-2009, 07:06 AM
#914
Does anybody have there hands on the championship edition rc8t, i back ordered mine from stormer hobbies but no luck yet. I just cant wait to get it.
Has anybody done electric conversions on the rc8t. That is my plan!!!!!
Has anybody done electric conversions on the rc8t. That is my plan!!!!!
