Need Help with IDing
 

I need help IDing this drive shaft:

Picture:
http://i232.photobucket.com/albums/e...6/SANY1236.jpg

Need the Replacement for it
It is not Traxxas
Its not Igenty
Its Not MIP
If you can ID it please give me a link to where I can buy a replacement.

I've searched everywhere all I come up with is the Traxxas drive shafts.


Thank You

I have a MRC (academy) RT4 GP Pro Spec. and the picture you have there, looks just like the axles on my rt4 GP prospec. (they look very close to a mip cvd)

im also from NH too

I did buy them from someone in NH

what did the axle come off of?

My E-Revo

im assuming its for the 1/16 scale revo not 1/10? if its the 1/16 scale erevo then its probably traxxas part number TRA7153. check out that part number on google.

Someone tried trading my a 1/16 erevo a couple weeks ago. its was a brushed version with a couple batteries and the newer 2.4 radio. would be funny if it was the same truck

I post a lot on Craigslist. sandown area.

Not the 1/16 the 1/10

oh ok, the 1/10 is tra5154. its pretty inexpensive. i actually have a bunch of unopen revo parts. i dont think i have this part number in my stuff but i can check.

or if you need the whole axle set, its part number tra5451r

I bought that part it is not right the hole for the pin is to small

worst case try drilling/boring it a little and see if that works. if not you may be looking at a new set of complete axles.

I will look and see if i have anything useful for you.

If there were blue boots over the cvd end like Traxxas shafts then they might be Tsais.

Oh damn should of thought boring out the hole......oh well ordered the Traxxas ones on Amazon should get here tomorrow thanks for the help