malinko1

how would i wire up 2 velineon brushless systems on 1 traxxas 2.4 receiver on my 4x4 monster truck?

Duster_360

iTrader: (21)

Usually a Y type servo harness is used.

RCaddict0

iTrader: (85)

I would sell them both and buy one bigger set up.

Alex.Eklund

iTrader: (1)

Here is my Twin VXL setup - I just used a parallel Y harness. It works pretty good since the motors are on seperate trans. Some times both systems are in tune but i go back to neutrual then they are good - I would NOT put 2 motors on the same driveline though ! Your just asking to strip spur gears when the motors get off sync. I would just buy a Castle Monster w 2200 and it would rip !

RCaddict0

iTrader: (85)

Thats bad azz! Did you complete this? Have you ran it with all wheels? You should put it on YouTube!

Alex.Eklund

iTrader: (1)

I have ran it with tires on a track but didn't get any video - it jumped decent for weighting a ton -
Here are a couple of snow videos from last winter



http://www.youtube.com/watch?v=vEBt3vlmpVg

http://www.youtube.com/watch?v=4e-5w5ZXCiU

wild248man

If u want them in sync. Try making the y harness equal. The wires going to the escs should be the same so they get the sginal at the same time.