![]() |
revo replacement engine
i have a revo 3.3 and im looking to replace the 3.3 engine, what do u guys suggest? i was going to do the os .18 tm but it is discontinued, i dont want to modify ne thing i want a bolt on motor that is better then the 3.3
thanks in advance daniel:batman: |
Originally Posted by daniel15fl
(Post 5739731)
i have a revo 3.3 and im looking to replace the 3.3 engine, what do u guys suggest? i was going to do the os .18 tm but it is discontinued, i dont want to modify ne thing i want a bolt on motor that is better then the 3.3
thanks in advance daniel:batman: |
Two years ago when my TRX 3.3 took a shit, I replaced it with a O.S .18TM. It was a good motor all around, but it kept leaking in the carb boot, and I could never get it to stop. Eventually I parted out the Revo
http://i100.photobucket.com/albums/m...x/olrevo15.jpg |
why not go with another 3.3 ? What about the 3.3 make you not want to get another?
|
it is very rare to have problems like this with an O.S engine. Usually they are top notch.
|
in my opinion i would go with the .18tz. if you want alot of power even though the tz has it go with a picco .26 if you go with a picco you can strip gears but not often. i have a .32 on my t-maxx and the only time i have to replace a gear is if im lean on the bottom end on purpose to do wheelies.:nod:
either motor is good but i would probly go with tz to race/bash and the picco to race:tire: |
Originally Posted by bigblockt-maxx
(Post 5740390)
in my opinion i would go with the .18tz. if you want alot of power even though the tz has it go with a picco .26 if you go with a picco you can strip gears but not often. i have a .32 on my t-maxx and the only time i have to replace a gear is if im lean on the bottom end on purpose to do wheelies.:nod:
either motor is good but i would probly go with tz to race/bash and the picco to race:tire: |
:nod:true, what i meant was for racing on a large, wide, damp track so you can go fast take wide turns and hook:nod:
|
Originally Posted by bigblockt-maxx
(Post 5740438)
:nod:true, what i meant was for racing on a large, wide, damp track so you can go fast take wide turns and hook:nod:
|
you can go with an O.S. 21 TM its a direct fit also picco makes a direct drop in for the revo you can use your easy start with both
|
Originally Posted by cassidy
(Post 5740034)
why not go with another 3.3 ? What about the 3.3 make you not want to get another?
|
i have never owned a 3.3 i have but i take them off without running them sell them on ebay make 120$ and buy somthing bigger like a picco. in my t-maxxes case i put a big block chassis on it and put a surefire .32 on it.:nod:
|
revo engines choices
most of the guys i race against with revos are using os 21 tm or os 18tz engines in them.
when i ran a nitro revo i went with the rb concept tm-523 and i loved the power of that engine. the 3.3 is ok for bashing but for racing its pretty much junk. |
i 100% agree:nod:
|
the 18tz is a great motor but is not a dirrect drop in. it uses the same mount but other mods are needed to make it work in a revo.
|
| All times are GMT -7. It is currently 02:46 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.