Minnesota local for sale wanted to buy thread 2015
#61
Tech Master
iTrader: (27)

Number of different generation Trinity motors. All used exclusively in 1/12th scale, never overheated.
Fantom D3.5 Works Edition 17.5, 12.5 High Torque D3 rotor.

Sold
Trinity 3.7v 6500mah 100c High Voltage LiPo. 5mm plugs.
Cycled twice, just to experiment with the HV chemistry. Peaked at 4.20, discharged to 3.50v. Going to stick with 4mm packs.

Sold
Xray 2.0mm Aluminum chassis (For T4'15). Light use, 1 scratch, flat and true.

$45
PM for fastest response, can meet at MMR or add $5.95 to ship.
Fantom D3.5 Works Edition 17.5, 12.5 High Torque D3 rotor.

Sold
Trinity 3.7v 6500mah 100c High Voltage LiPo. 5mm plugs.
Cycled twice, just to experiment with the HV chemistry. Peaked at 4.20, discharged to 3.50v. Going to stick with 4mm packs.

Sold
Xray 2.0mm Aluminum chassis (For T4'15). Light use, 1 scratch, flat and true.

$45
PM for fastest response, can meet at MMR or add $5.95 to ship.
Last edited by Dan Hamann; 05-26-2015 at 05:52 PM.
#63

Holy cow, are these tires still available? Yes they are!!!
Lots of tires!
About 20 sets of 1/12th and 6 sets of 1/10th foams.
All new, never ran - a few have been trued.
Lots of lilac fronts, yellow or white rears, plus some other misc flavors.
Looking for a good home, first $25 takes them all.
FREE SHIPPING TO MINNESOTA, WISCONSIN OR CLOSE LIKE THAT!
Best contact is [email protected]
tx
Charlie Menard
About 20 sets of 1/12th and 6 sets of 1/10th foams.
All new, never ran - a few have been trued.
Lots of lilac fronts, yellow or white rears, plus some other misc flavors.
Looking for a good home, first $25 takes them all.
FREE SHIPPING TO MINNESOTA, WISCONSIN OR CLOSE LIKE THAT!
Best contact is [email protected]
tx
Charlie Menard
#64
Tech Adept
iTrader: (3)

1 saddle pack 6000 mah 2s
90 c
Used 3 runs bought new 74.95$
New wheeler needs shorty pack
50$ Obo
Located in Plymouth area can ship if needed
Write for pic
[email protected]
90 c
Used 3 runs bought new 74.95$
New wheeler needs shorty pack
50$ Obo
Located in Plymouth area can ship if needed
Write for pic
[email protected]
#65
Tech Apprentice
iTrader: (5)

I'm looking to buy a cheap TC5 chassis. I figure someone might be dumping one to get ready for the summer off-road season. I don't need electronics.
PM or email: [email protected]
PM or email: [email protected]
#67

My oldest son Jake is getting out of the racing scene and wants to sell his B5M. The car itself is basically stock. Relatively low mileage Tekin Gen2 17.5 RPM motor, Viper VTX10 Black Edition ESC with EZLink, Spektrum 6040 servo, Airtronics receiver, and a Mylaps 2 wire transponder. Also includes his parts, springs, tools, toolbox, 2 radio bags, and a few other random bits and pieces. Asking $450 for the whole shootin' match. Obviously not looking for trades at this stage. Paypal only.








#68
Tech Initiate
iTrader: (3)

I was doing some cleaning and found a few of my old Rs4 Mt parts, if anyone local wants them let me know. There is an a arm and a battery strap and also I think a front bulkhead brace. Not sure on all the parts but they will be free to anyone local that can meet up. I don't know if they are hard to find but they should go to someone that can use them.
#71
Tech Regular
iTrader: (21)

i have a losi scte 2.0 in really good shape well taken care of. Just took first today down at lucky 13 speedway. Will sell with Hobby wing short course esc and reedy sonic 4300kv short course brushless setup. Both work excellent. Also comes with a brand new chassis protector, basically brand new set of proline tazor tires (only used twice), set of bald typos just used to play around with on the street, and also a brand new set still in package proline electrons. bunch of misc. parts and tuning options such as springs, camber and toe adjustments, extra screws and couple center drive shafts and new chassis braces. Only looking to sell becasue i would like a t5m to go along with my b5m. will be alot easier to go back and forth between classes with basically the same cars rather than 4 wheel to 2 wheel. please pm me if interested.
$425 or best offer. buyer pays shipping if we cannot meet up.
thanks,
nick






$425 or best offer. buyer pays shipping if we cannot meet up.
thanks,
nick






