R/C Tech Forums

Go Back   R/C Tech Forums > Members List

tnt2671 tnt2671 is offline

Tech Regular

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. AdrianM
    04-23-2013 09:25 AM - permalink
    AdrianM
    Sorry I missed this.

    I moved the ball studs back to the end hole with the servo mounted full forward (both servo spacers). The tie rods sweeping back reduces ackermann. If the inside wheel turns too much (from too much ackernamm) you lose corner speed.

    For rim clearance I bevel the inside of the rim with an xacto knife and run the old closed/small AE ball cups. They are lower profile. I run the tall ball stud with 1.5mm of spacers to get rid of almost all of the bump steer.
  2. djfootball
    12-26-2012 06:42 AM - permalink
    djfootball
    Hello,

    I'm interested in your DX6i. Is it still available? If so, I was wondering if you'd take any less for it. If you'd take $125 I'll send you the $$ via paypal today.

    Thanks for your time,

    Brian

About Me

  • About tnt2671
    Location
    springfield, ma.

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 07-18-2015 12:07 PM
  • Join Date: 12-11-2003
  • Referrals: 0

Contact Info

Instant Messaging
Send an Instant Message to tnt2671 Using...
This Page
https://www.rctech.net/forum/members/tnt2671-10301.html

All times are GMT -7. It is currently 05:53 AM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.
Powered By: vBulletin v3.9.2.1
Privacy Policy | Terms of Use | Advertise Content © 2001-2011 RCTech.net