Hey Howard,
I have the new pro esc and Bluetooth module,and I've pretty much worked them out.
My Bluetooth module arrived as a circuit board with plastic on it and I've been able to upload the relevant software/firmware to my android device.
I know it's possible to just mount it to the top of my servo and adjust settings as I drive,but this is only to allow me to test various settings as I wouldn't be able to race with it as its quite visible.
To be able to adjust timing from the drivers stand is great for testing,I just pull over into a neutral zone on our track and stop.
Is this why the unit is so small?
To use in testing?
Thanks for your time,
Regards
Tim Phillips

Need help I wont a new motor and thinking speed passion but wich one SCT 17.5 boosted and trubo will be racing only

HI!!Α member told me that you are working in sp!!i bought a sp cirtix club esc used from ebay but i have a problem!
i read carefuly the instr manual so to calibrate with the motor(sp competition 3)!
but after calibrating red led is blinking(manual says that red led bliking when detects low voltage)and nothing work exept fan !i tested several times with other 2s battery that was fully charged even test the motor with other esc and it runs great!that means that motor and batterys are ok !i even checked with other transmitter but after many hours calibrating many times and testing still the same thing!what can cause this problem??the esc seems to be new and seller said that he just calibrate to see if it is ok and didnt even run it in his car!
so i cant understand whats gonig wrong!!!
toyr help will be too important for if you can imaging whats fault!!!
Thank you !!!