R/C Tech Forums - Conversation Between shaner222 and mbtoolmaker35

Go Back  R/C Tech Forums > shaner222
Reload this Page >

Conversation Between shaner222 and mbtoolmaker35

Conversation Between shaner222 and mbtoolmaker35
Showing Visitor Messages 1 to 2 of 2
  1. mbtoolmaker35
    09-28-2013 08:21 PM - permalink
    Well if you have access to machinery you could drill mill it out and re tap. I do prefer to sell as a set and is how I offer them on www.rocket-rc-parts.com. feel free to email me at [email protected] we will figure out something also you will see we offer new 2.0 sliders and more.

    Thanks
    Michael
  2. shaner222
    09-28-2013 03:01 PM - permalink
    hi
    i bought a 22 sct steering rack and finished my out door season went to remove for indoor clean up but snapped screw inside the rack tiny bit stickin out not enough to grab
    1-any ideas to get out?
    2-can i buy just rack as brass slide is perfect or does the entire unit need to be made as pair?
    3- cost of aluminium rack ?
    great job by way think it was graphite powder that cause binding in rack causing screw to bind and snap

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.