R/C Tech Forums - View Profile: Oztiger

Go Back  R/C Tech Forums > Members List
Reload this Page >

Oztiger's Profile

Oztiger Oztiger is offline

Tech Regular

About Me

  • About Oztiger
    Queensland Australia
    1/10 elec short course
    You dont want to know
  • Signature
    SCTE 2 4x4 RX8 V2 esc 4200HD Tekin 4pole motor
    B5M Lite, Trackstar 120 amp Gen 11, GForce extreme 17.5
    Durango 410 V4, GForce 160 amp, 10.5 turn brushless


Total Posts
Visitor Messages
General Information
  • Last Activity: 07-24-2016 10:54 PM
  • Join Date: 10-28-2004
  • Referrals: 3


Showing Friends 1 to 1 of 1

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. Oztiger
    02-12-2012 05:50 PM - permalink
    Sure, sorry for the late reply. I run the Tekin stuff, RX 8 and the 1900kv motor. I run the Tekno 18 tooth clutch bell with soft springs. took the servo brake off as I couldnt get the right drag and the car would roll too fast into corners. My opinion is motor brakes with a little drag set in is best. I use 4500mha 35c Turnigy packs for heats and 5800 Zippy40c for finals.
  2. 02-01-2012 04:48 PM - permalink
    I just converted my RC8B to the RC8 Tekno V4. I am running Rx8 and 1900KV T8. What do you have in yours for pinion and spur and what motor are you running? Thanks

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.