R/C Tech Forums - Conversation Between linkless and ScottE1776

Go Back  R/C Tech Forums > linkless
Reload this Page >

Conversation Between linkless and ScottE1776

Conversation Between linkless and ScottE1776
Showing Visitor Messages 1 to 5 of 5
  1. ScottE1776
    07-27-2013 10:59 PM - permalink
    Is onroad running tomorrow at CH
  2. 07-25-2013 04:31 PM - permalink
    No problem, I was shocked to find such a low roll out but ended up with the fastest laps in the main so it can't be to far off. I too was shocked at the gearing on the brushless motors, it seems that the hottest modifieds are running what we use dto run with stock motors.
  3. ScottE1776
    07-24-2013 10:46 PM - permalink
    Thanks John. I assumed you were running 40mm tires and so I didn't ask about them. Big mistake on my part. I had heard that a good starting point was 95 rollout and that was SUCH a big change for pinion and spur from long ago that I thought I'd check with you, Lonny and Evan. Thanks again
  4. 07-24-2013 10:41 PM - permalink
    We typically talk rollout when asking about gearing for foam tired pan cars. I had 42mm tires, with a 48 pinion and a 76 spur. This equates to (76/48)*3.14159*42 which is 83mm of rollout. I am running a Speed Passion 1 cell 17.5 set at 20 degrees of timing. The current SP motor is the MMM and I would gear it the same with the same timing. I honestly thought I was closer to 90mm on rollout and will likely be trying it on Sunday, my first run with the car had the axle to tight on the bearings which caused heat. I geared down before finding the tight axle and never geared back up.
  5. ScottE1776
    07-24-2013 08:24 PM - permalink
    John:
    What spur, pinon and motor were you running last Sunday. Trying to get a close approx on where to start.


    also what of the above for WGT would be a good start as well.
    Thanks Scott.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.