R/C Tech Forums - View Profile: JSurr

Go Back  R/C Tech Forums > Members List
Reload this Page >

JSurr's Profile

JSurr JSurr is offline

Tech Adept

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 12-23-2021 09:32 PM
  • Join Date: 01-23-2011
  • Referrals: 0

Friends

Showing Friends 1 to 1 of 1

Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. Goof
    01-17-2014 05:54 PM - permalink
    I'm here man what's up?
  2. 12-04-2013 01:27 PM - permalink
    Since the serial number is not a US sold version I cannot service it for you. You will need to contact KO Japan or the dealer where you purchased it from. You might need to replace the antenna or just have it checked for short range in the Master Unit.
  3. xtmwill
    12-02-2013 07:46 PM - permalink
    haven't got ur messege yet whats your ???
  4. 10-17-2013 10:29 AM - permalink
    Perform the AdjustTH function to calibrate the grip unit to the Master Unit. Then verify the movement in the Monitor function. If this is correct then it should be operating correctly.

    If you connect a servo to CH2 you should be able to see the movement in the servo as you move the trigger.

    If you are using this for electric, then you will need to set the ESC to the transmitter. Please refer to the ESC manufacturer's instructions for setting this up.

    In order to verify the movement on the transmitter to the receiver, make sure that you have paired the receiver to the transmitter first.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.