R/C Tech Forums - View Profile: icecyc1

Go Back  R/C Tech Forums > Members List
Reload this Page >

icecyc1's Profile

icecyc1 icecyc1 is offline

Tech Adept

About Me

  • About icecyc1
    Country of Residence
  • Signature
    Shock Dyno Test Results: https://sites.google.com/site/rccarengineering/home
    Shock Dyno Thread: https://www.rctech.net/forum/electric-off-road/865246-rc-shock-dyno-test-results.html


Total Posts
Visitor Messages
General Information
  • Last Activity: 01-08-2024 01:12 AM
  • Join Date: 09-13-2014
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. 10-27-2017 10:27 AM - permalink
    Hi Scott,
    I am contacting you regarding the dynamometer test results that you have published. I am using RC scale shocks to do earthquake engineering experiments in buildings.
    At the moment, I am testing traxxas GTR shocks in a setup similar to the dynamometer you have shown in your report. I have an electromagnetic shaker displacing the shock piston in a sinusoidal fashion. I have a load cell connected in series with the shock to record force, and the piston motion is also being recorded.
    Unfortunately, I was unable to get any linear response from the shocks and there always seems to be lag between the force I am recording, and the velocity of the piston. I have even gone to the extent of testing the damper with no cap (open to air) but I still see this lag.
    I am wondering whether you had to do any post processing of your force traces to capture the linear damper trends you show. I would really appreciate any advice you may have on this.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.