R/C Tech Forums - Conversation Between GerryH and SidTSloth

Go Back  R/C Tech Forums > GerryH
Reload this Page >

Conversation Between GerryH and SidTSloth

Conversation Between GerryH and SidTSloth
Showing Visitor Messages 1 to 2 of 2
  1. 01-16-2019 03:44 AM - permalink
    Hey, Thanks for the response, I read it as you had created yourself an arduino motor analyzer. I was trying to work out a simple way to do it.

    I can easily control an esc from an arduino, I can read both voltage and current before the esc, and I should be able to read the pulses on the sensor board too.... Just need to get my head around how the analyzers interpret timing etc. I am not sure its even possible without effectively creating your own esc to drive it.

  2. 01-15-2019 03:59 AM - permalink

    I saw your post about having built an arduino based rotor tester. Do you have any more information on this?
    Im curious about building something similar, and have an ardiuino and hall sensors so can read the RPM, but do you use a speed controller or have you also got a drive unit too?
    Also where do you read the current etc, on input to the speedy / motor.

    Any info would be gratefully received.

    Regards, Sid.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.