R/C Tech Forums - Conversation Between fyrstormer and Schick2583

Go Back  R/C Tech Forums > fyrstormer
Reload this Page >

Conversation Between fyrstormer and Schick2583

Conversation Between fyrstormer and Schick2583
Showing Visitor Messages 1 to 2 of 2
  1. fyrstormer
    03-23-2022 10:06 PM - permalink
    The clutch bell didn't require modding the engine, but I did need to use a longer pilot shaft on the end of the crankshaft, and a pair of flanged 5x8x2.5 ball bearings for the clutch bell to rotate on.
  2. 03-23-2022 02:41 PM - permalink
    Hey, I just found this form and saw you changed your clutch on your NTC3, I was wondering if the HPI 15t/21t 2-speed clutch bell you used bolted right up without any mods? I've had this car since new back in 2005, put it away and just found it again, put fuel in it, it started right up, was driving it around and burned up my clutch shoes, any help would be appreciated, thanks, Tom.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Your Privacy Choices -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.