OK cheers for the heads up. I will go back and check all the settings. Do you scroll up on the slider till you get the custom voltage cut off ? What do you think 3.2 volts would be ok.
Voltage booster should be here sometime this week so will let you know how it goes.
Thanks for the help though Darren
Hi Darren, re your problem with esc, it sounds as though you have not set the voltage cut off properly -- the 1s box needs to be ticked and the custom voltage cut off set.
Re the voltage boosters you were asking about I have been using them for the past 18 mnths and they are good ( soldering is a bit suspect as if you waggle wire too much the joint of the wire onto the booster board will break).
If you get to any of the UK 1/12 nationals pop over and say hello to me, Rob Shepherd.