Go Back  R/C Tech Forums > Members List
Reload this Page >

anfhockey10's Profile

anfhockey10 anfhockey10 is offline

Tech Rookie


Total Posts
Visitor Messages
General Information
  • Last Activity: 05-08-2011 03:48 PM
  • Join Date: 05-08-2011
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. OTE_TheMissile
    05-09-2011 09:08 AM - permalink
    Yeah, it's almost like either the engine sits a little too high or the flywheel is a little too small. Either way, you can check by removing the engine and pressing down on the box like you normally would. You should be able to fully depress the truck on the box and still have the bump box wheel spin freely in the chassis slot.

    Your best bet is to just grind on it, check it, grind some more, check again, etc. etc. until it fits. I had to remove quite a lot of chassis material to get it to work on my OFNA Stainless box, I'd recommend using a Dremel with a high-speed cutter bit to start, then once you have it working clean up the rough edge with a grinding stone. If you use a hand file you might get done by November

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.