Hello. You were referred to me as a fellow that is running a TC3 in VTA with some success so I thought I would see if I could get some setup advice. I have been racing RC on and off road for several years so I am not completely without knowledge. I currently have a speedworks carbon fiber chassis with all the TC3 driveline. It seems like the other touring cars on rubber tend to push but I have the opposite loose in the rear condition, particularly when accelerating out of a corner. I currently have the car set up soft and with no swaybars. I have tried to tighten the front by stiffer springs only to have a push coming in and still loose going out. I know there are a huge amount of variables but would appreciate any pointers or setup advice that you could offer. Thanks in advance, Michael