My track is the same: tight high traction so I will try your setup out.
Thanks for the info, Much appreciated!

Thanks for the info - much appreciated! I got some more if you don't mind?
What are you running for shock oil weights, main and side? I have a short Tamiya red (12.4) and an Associated green spring (11.4 lb). I have the stock side springs and the Taimiya front spring set - soft, med and firm.

Not sure where to start!
Thanks again!

I read your post about tuning the Exotek F1R and had a couple of questions for you. This is my first F1 car and haven't raced a pan car in almost 20 years!

You are measuring rear droop at the rear of the pod? There is no mention of droop on the Exotek build sheet? When a friend first built his he had set his shock up too long, when he accelerated the chassis would raise up quite a bit! It did seem to transfer a lot of weight and didn't appear to adversly effect handling though?

What fluid/grease are you using for dampning on the front kingpins?

Thanks!