R/C Tech Forums - View Profile: malik

Go Back  R/C Tech Forums > Members List
Reload this Page >

malik's Profile

malik malik is offline

Tech Elite

About Me

  • About malik
    Location
    Erie Pa.
    Interests
    Duh
    Occupation
    Barber
  • Signature
    TT MT4G3 all tricked
    TTST4G3 MT4ed out

    JR servos Hitec servos. Gens ace lipos KO radio.

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 04-29-2014 04:29 PM
  • Join Date: 03-28-2008
  • Referrals: 0

Friends

Showing Friends 1 to 5 of 5

Visitor Messages

Showing Visitor Messages 1 to 5 of 5
  1. 05-06-2009 10:40 AM - permalink
    Hey whats up. Was running my buggy today (d8) for another break in session and I lost steering and tapped a small pole.

    The reason I lost steering was because the arm for the steering servo stripped out. maybe I did not have my epa adjusted correctly. But during this little crash I had the screws to pull out of the bulk head on the front. It was the screws going into the rear. The hinge pins seem to be ok as well as the hinge pin plates. To prevent this from happening in a race can I get a alum servo horn. I am using a ace steering servo the 1313.

    Also would you take the chance on running the same bulkhead or would you get another to replace it.
  2. 02-22-2009 03:35 PM - permalink
    how do u like the go tech 5 port on your hot bodies d8 i have a hot bodies d8 and a os vg .21 and was woundering if i switched to the go tech 5 port would it be any faster and if the engine last
  3. 02-11-2009 12:25 PM - permalink
    I am trying to find us mail order fuel cheap. My chassis is out getting 4 oz taken off of it and my bodie is out getting done also. And Powerhouse just shipped my mill back to me TKO ceramics new rod pin clips o-rings the works.
  4. jazjato
    02-11-2009 06:56 AM - permalink
    Hey,

    how's that d8 coming along??? Already doing small mods to the Z that I've found on the forums. Anything else going on?
  5. 01-09-2009 03:34 AM - permalink
    .

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.