aracefan

iTrader: (70)

I tried to find where to order one a week or two ago, and had no luck... went ahead and got the F6.

hanulec,
I clicked on your link in your sig but still found nowhere to actually order - and no instructions on how to order either. So, do you have to send an email that you want one and wait for a reply?? Just curious, as I would still like one of these.

Thanks in advance.

iTz Nicholas72

iTrader: (19)

http://shop.rochercusa.com/index.php?route=product/product&product_id=386

aracefan

iTrader: (70)

Thanks! I'm not normally "internet challenged".

JoeRocket

iTrader: (1)

Any chance that you can post the setup for this hot rod?

Kevin CBR

iTrader: (11)

[QUOTE=gabc;15070952]Thanks Panda! Any idea how many additional mm this will give me over the stock ones?

The aluminum rear pod was thinner than the graphite so the axle was lower to the ground. Don't remember the difference it gained. Just remember it got me to 5.0 ride height as I was running outdoor.

Panda

gabc

iTrader: (15)

Thanks Panda, I'll check the rear pod out.

Gab

gabc

iTrader: (15)

Hey Barry, good to see you here! 😀

Gab

iTz Nicholas72

iTrader: (19)

Any chance we'll see a USA Spec Evo with the Aluminium chassis?

hanulec

iTrader: (28)

Doubtful
Unless it is faster
Don't even have production chassis yet...

liljohn1064

iTrader: (17)

The current answer is: In my hands. Thanks ActivRC.com

nicoo2k4

Alu chassis still prototype, should be release soon!

sg1

iTrader: (79)

I never made a set up sheet, but I can give you a few things I did that worked:

Front
9* castor
2* camber
.018" assoc. springs with 1.5mm sag
3/4 SXT sauce
sidewalls glued to seam
1mm shims on axles
3oz. weight in front
lowered upper graphite plate 3mm to change roll center
Protoform wing

Center
CRC shock with 42.5wt and red spring
1.5mm droop
.45 CRC side springs
15K Kyosho grease in 1 tube and 30K Kyosho grease in the other tube

Rear
Fenix gear diff with 30K Kyosho Grease
Protoform wing mounted as low as possible and as close to rear axle.
Team Scream 25.5
WTF fan on top of rear pod
Full SXT sauce

Montech '15 body

JoeRocket

iTrader: (1)

Thanks. I am building mine later this week. I will keep some of those tips in mind when building it.

gabc

iTrader: (15)

May I know what's the reason behind this, and how this affects handling? Thanks!

Gab

hanulec

iTrader: (28)

its to get thicker but not too think -- ie both of heavier weights in both tubes

the thicker dampening slows reactions slightly and helps the car keep its 'set'