Xray X10 to WGTR
What is needed to convert the Xray X10 to a WGTR? Other than tires and wheels.
|
I will assume that ride height needs to be addressed. Spec for the class is 5mm minimum. The tires are tall so you might need shimming to get close to that. I don't know how X-Ray adjusts rear height but on a car that accepts Associated type adjusting inserts, just find a set of #4. The front end will need about 2.5 to 3mm of extra shim. Don't forget to set the servo height for the front end change.
|
Heard people were using X1 motor plates with the pill imserts.
|
A racer did a conversion to his X-ray wgt and its one of the fastest cars
idbdoug |
Some parts from Fenix for the Xray 10-2018 and 2016:
Chassis brace: https://cimg6.ibsrv.net/gimg/www.rct...955f02e8b5.jpg https://cimg9.ibsrv.net/gimg/www.rct...50031db7fa.jpg Motor shoulder brace: https://cimg4.ibsrv.net/gimg/www.rct...7db6ddf5aa.jpg https://cimg5.ibsrv.net/gimg/www.rct...b953b6db4d.jpg |
On the 2018:
5mm spacers for rear axle mount and longer screws 3mm spacers under the front arm mounting brace and longer screws then use supplied spacers to fine tune Car is fast! |
Originally Posted by Dan
(Post 15021611)
Heard people were using X1 motor plates with the pill imserts.
|
Originally Posted by Vintagedriver
(Post 15188013)
Agreed. To avoid major shimming use X1 rear bulkheads
|
anybody know if I can fit a 2018 chassi plate on a X10 2015 ?
|
All times are GMT -7. It is currently 06:39 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.